SPEEDFIT Shaft Lighting Kits

Speedfit is an entirely new concept in shaft lighting and power installation.

During trial tests, a 15 floor Speedfit shaft lighting kit reduced installation time by 65%, compared to a traditional hard-wired conduit type installation.
Speedfit has taken the concept of 'plug and play' to the next level. This unique 7 wire system enables installation of multiple combinations of standard mains lighting, emergency lighting and power sockets within the same circuit.
Speedfit's unique flexibility makes the retrospective installation of additional light fittings, intermediate light switches and RCD power sockets both simple and fast.
Speedfit light fittings are IP65 rated eweatherpackf type, available in both 2ft and 4 ft twin, standard or maintained emergency. All fittings are pre-wired at both ends with a 1.5 metre length of 7 wire LSOH cable and plug, giving an approximate distance between light fittings of 3 metres. This distance can be adjusted by using one of the extender leads detailed in the order table.
All Speedfit components are pre-wired and mounted on fixing brackets. Another unique feature of Speedfit is that the light fitting brackets run vertically down the back of the fitting, requiring only two fixing positions. Most other types on the market use lateral brackets containing four fixings per light fitting. It stands to reason, therefore, that PEW Speedfit fittings can be installed in half the time!
All Speedfit shaft lighting kits are supplied complete with all necessary mains adaptors, extender leads, cable fixings, screws and rawlplugs.
Speedfit shaft lighting kits are available from 2 to 20 floor. As standard, we offer the following combinations of kits, which are detailed in the order table on page. Speedfit shaft light kits are available in the following formats:
All fittings are standard mains
Every 3rd fitting is emergency
Every 2nd fitting is emergency
All fittings are emergency